Flame Arrestors

Operation
Flame Arrestors, detonation flame arrestors, detonation arrestors, flame detonation arrestors stop the propagation of a flame by absorbing and dissipating heat through the large surface area of the bank sheets. Ignited vapour attempting to pass through the arrestor is forced through small passages within the bank assembly. Heat is absorbed, lowering the temperature of the gas below its ignition point and quenching the flame. Flame Arresters are typically used in the chemical, petrochemical and pharmaceutical industries on applications such as storage tank facilities, flare stacks, incineration systems, storage tank roofs or digester convertor to prevent the propagation of confined and unconfined delfagrations. Detonation flame Arresters additionally stop the high pressures and velocities that can result in detonations. Incase of ignition of vapours they burn harmlessly at the flame arrestor, preventing ignition of vapours in the tank and subsequent explosion.
Design Features
The main benefits of the 'Fuidyne Atmos®. detonation flame Arrestor, flame arrestors, detonation arrestors, flame detonation arrestors are derived from ifs unique element design. The large channel openings provide excellent pressure drop to flow and enhanced flow characteristics often resulting in reducing overall size and cost of both Flame arrestor and piping. In addition to this the less restrictive nature of the larger channel openings result in less clogging and easier cleaning - both important maintenance considerations. Finally the element enables higher operating pressures to be achieved. The 'Fluidyne Atmos®' Flame Arrestor after extensive research has been certified and type tested by FCRI, B.V. and other government agencies, and has also received the most stringent approval for Flame Arrestors, incorporating extended burn time performance, and have acceptance with B.P.C.L, I.O.C.L, H.P.C.L, L & T , REL , RIL & B.H.E.L., and many chemical, pharmaceutical , power industries and petrochemical industries.
Configuration
'Fluidyne Atmos®' Flame Arrestors are available for all common gas groupings to IEC or NEC codes, and supplied in range of sizes/materials/options; Net Free Area - three to four times, Bank Assembly - estensible and removable. Special "off-set" housing design is not affected by condensate accumulation, even when installed in horizontal piping. The result is minimal pressure drop, increased flow capacity and heat dissipation. Ordering information given below

Size: 1" to 36" Refer graph for sizing.	Location: Within 15' (4.6m) upstream of flame source.	Pressure Dop: Refer Graph, Should Not Exceed 1 PSI.	Materials: Low Copper aluminum, steel, SS 304/316 stainless steel.
Codes: API, ASME, CCE, IS etc.	Tests: Type test, pr, drop, flame propagation, API 2000.	Element: Plate stack or crimped metal	Installation: In-line, end-of-line, inverted, weather hood requirement.

Our Other Products: Breather Valves, Emergency Vents, Gauge Hatch, Spark Arrestors